Scope DataPage Mark 2 Manuel d'utilisateur Page 1

DataPDataPDataPDataPDataPage MK2age MK2age MK2age MK2age MK2Desktop UHF Radio Paging SystemScope Communications UK Ltd, Quantum House, Steamer Quay, T

Scope DataPage UHF MK2 Radio Paging System DPMK2/6 9 07/05 Pressing key 1 will display Normally Open Pressing key 2 will display Normally Closed P

Scope DataPage UHF MK2 Radio Paging System DPMK2/6 10 07/05 3: Phone (refer also to Section 2: Telephone Interface) This section is only applicabl

Scope DataPage UHF MK2 Radio Paging System DPMK2/6 11 07/05 4: Serial After pressing ENTER, the display will change to: STOP BITS (1-2):

Scope DataPage UHF MK2 Radio Paging System DPMK2/6 12 07/05 Section 2 Telephone Interface (models NDPDTMF and NDPLP only) Overview IMPORTANT!

Scope DataPage UHF MK2 Radio Paging System DPMK2/6 13 07/05 Section 2 Telephone Interface (models NDPDTMF and NDPLP only) Numeric pagers STEP 1

Scope DataPage UHF MK2 Radio Paging System DPMK2/6 1 07/05 PREFACE Important Installation Information It is the purchasers’ responsibility to det

Scope DataPage UHF MK2 Radio Paging System DPMK2/6 2 07/05 Preface Installation Installation must only be undertaken by an Approved contractor, w

Scope DataPage UHF MK2 Radio Paging System DPMK2/6 3 07/05 Contents of this box: DataPage Mk 2 UHF Base Station Plugtop Power Supply Internal Ant

Scope DataPage UHF MK2 Radio Paging System DPMK2/6 4 07/05 Description: Your DataPage Mark 2 is supplied in one of three configurations: 1) NDP, t

Scope DataPage UHF MK2 Radio Paging System DPMK2/6 5 07/05 System Operation 1) Connect the 90 degree aerial to the BNC connector (bayonet twist loc

Scope DataPage UHF MK2 Radio Paging System DPMK2/6 6 07/05 Fig. 1 Connecting the antenna and locking cover Fig. 2 Connection port detai

Scope DataPage UHF MK2 Radio Paging System DPMK2/6 7 07/05 Group Calls As previously stated, this system will accept pager identities from number 1

Scope DataPage UHF MK2 Radio Paging System DPMK2/6 8 07/05 Program Parameters The standard models are factory pre-set and should not under any cir